Abbott Precision XceedPro Návod k obsluze stáhnout pdf (Strana 4)

Title (with LTR): Precision Xceed Glucose Procedure (LTR19678)

Last Approved: Gregory, Kimberly (Electronic Signature Timestamp: 8/11/2014 3:20:23 PM)

Comment Codes (Use optional)

COMMENT CODES

0 No Action Required

1 Repeat Test

2 New Test Strip Box

3 New Control Bottle

4 Procedure Error

5 New Test Strip Lot

6 New Control Lot

7 Changed Monitor

8 Changed Batteries

9 Repeat Test, Notify Clinician,

and Send Sample to Lab

11 See Patient Record

15 Training

Test Kits/Supplies/Equipment

Product Manufacturer # Distributed by MGH

PeopleSoft #

Storage

Glucose Precision Xceed

Pro strips

– 100/box

Abbott #70932-01 Owens/Minor 330220 39 - 86°C

Precision Glucose Control

Solution – High/Low, one

bottle of each/box

MediSense #98411-01 Owens/Minor 39961 39 - 86°C

Glucose and Ketone

Calibration verification

Controls (5 levels)

POCT program use only

Abbott #70906-01 N/A

Special request

36 - 86°C

Maintenance

The Precision Xceed Pro™ Monitor requires little routine maintenance. During testing, the sample remains outside the

monitor, which significantly reduces the possibility of contamination.

Disinfecting the Exterior Surface

Disinfecting the exterior surface of the Precision Xceed Pro Monitor is required after each use. The monitor needs only

to be wiped down after use with hospital-approved disinfectant. It is suggested that the monitor be turned off while it is

being cleaned.

DO NOT immerse, flood with any liquid, or autoclave the monitor. Disinfecting after use need not be

documented since this is part of the operating procedure.

Replacing the Batteries (used for replacing alkaline batteries)

Use the following procedure to install new batteries in the Precision Xceed Pro monitor. The Monitor requires two (2)

AA alkaline batteries

1. Turn the Xceed Pro Monitor off by pressing the On/Off button on the keypad.

2. Turn the monitor over to view the battery compartment.

3. Press the tab on the battery compartment cover and lift the cover up.

4. Remove and discard the used batteries.

5. Insert the new batteries, using the + and – symbols in the battery compartment to position the new

batteries with the correct polarity.

1 2 3 4 5 6 7 8 9 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Abbott Precision XceedPro Návod k obsluze Strana 4

Komentáře k této Příručce